Aluminum plastic panel processing and installation methods

Views:12 Author:Site Editor Publish Time:2026-09-20 15:07:01 Orgin:Site

share

丨Processing method

Aluminum plastic composite panels can be cut, sawed, milled, punched, pressed, folded, bent and other processed into various shapes using tools for processing wood or metal. They can be processed into various shapes according to the requirements of architectural decoration design, especially for curved, reverse curved, small radius rounded corners, inner and outer corners, etc., which cannot be compared with other decoration materials. Ordinary aluminum processing machinery and wood processing machinery can be used for the processing of aluminum-plastic panels without special equipment.

Aluminum plastic panel slotted sheet: U-shaped, V-shaped

丨Sawing processing

Wood products can be easily processed using mechanical saws and boards.

Recommend  using hard alloy blades.

丨Cutting and processing grooves

It is important to maintain a U-shaped groove processing distance of 0.2-0.4mm from the polyethylene base surface. The recommended optimal groove angle is 110 degrees.

(1)Milling machine and trimmer

Use the modified drill bit as shown in the following figure.

Number of teeth: 2-4

Rotation speed: 20000-30000rpm

Feed speed: 3-5m/min

Material: Hard alloy

(2)When processing a large number of U-shaped grooves, it is appropriate to use circular saws and band saws.

The following example shows an example of a slotted knife

Material: Hard alloy sheet

Outer diameter: 305mm

Number of teeth: 24

Rotation speed: 3000-5000rpm

Cutting speed: 5m/min

丨Bending processing

Operations and curved parts can be done neatly on the platform. Flat punch presses, folding machines, or bending molds are suitable as bending equipment. We recommend temperatures above 10 ° C when bending.

丨Bending and processing with a folding plate machine

When using a folding trigger shaping plate, an appropriate radius upper mold should be used.

丨Bending and processing with a three roll trigger

The three roll bending trigger is more suitable for bending large inner diameters than the folding trigger. And it should be done before bending and can be bent by hand after bending.

丨Riveting processing

Blind rivets can be easily connected from one direction

丨Bolt connection

From the perspective of deformation limit, e ≥ 2D in the figure.

丨Installation Diagram

丨Examples of board types and connection design

Aluminum corner and sealed connection

1、Aluminum plastic panel

2、Aluminum nail

3、Aluminum corner (large)

4、Aluminum corner (small)

5、Sealing material

6、 Lining material

7、Gasket

8、Angle steel

9、 Round head screw

丨Example of cylindrical wrapping

1、Aluminum plastic panel

2、Corner support

3、Steel strip

4、 Sealing material

5、Plastic lining

6、 Accessory device

7、 Round head screw

8、 Load bearing column

9、Angle steel

The above auxiliary devices are suitable for low rise buildings

丨Example of installation at the top of a building

1、Aluminum plastic panel

2、Building top

3、Corner support

4、Corner support

5、Angle steel

6、Sealing material

7、Lining material

8、Round head screw

9、Pre embedded anchoring or expansion bolts

丨Example installation at external corners

1、Aluminum plastic panel

2、Sealing material

3、Lining material

4、Angle steel

5、Steel strip

丨Example installation at internal corners

1、Aluminum plastic panel

2、Sealing material

3、Lining material

4、Angle steel

5、Round head screw

丨Example of Square Column Coating

1、Aluminum plastic panel

2、Corner support

3、Angle steel

4、Sealing material

5、Plastic pad lining